16
• Bobbin Winding
PLEASE NOTE:
Set the slide speed control at its fastest position for bobbin
winding.
Draw the thread from the spool and pass the thread around
the bobbin winding tension disc.
Bobbin winder tension disc
Thread through the hole in the bobbin from the inside to the
outside.
Put the bobbin on the bobbin winder spindle.
Push the bobbin to the right. The bobbin icon appears on
the LCD display.
Bobbin icon
With the free end of the thread held in your hand, start the
machine. Stop the machine when it has wound a few layers,
and then cut the thread close to the hole in the bobbin.
PLEASE NOTE:
For safety purposes, the machine will automatically
stop 1.5 minutes after starting bobbin winding.
Start the machine. When the bobbin is fully wound, it will
stop automatically. Stop the machine and return the slide
speed control position. Shift the bobbin winder spindle to
the left for stitching. Cut the thread as shown.
Remove the bobbin. Cut the thread as shown. Return the
slide speed control position.
To Next Page
Loading...
