Settings, practical sewing
Sewing in tape
The standard presser foot is equipped with a tape guide. A tape can
be sewn into the shoulder or side seams of garments made from
knits or stretch fabrics to prevent stretching.
• Turn the handwheel towards you until needles are fully raised.
• Raise the presser foot.
• Lay the tape under the presser foot and slide it carefully into
the tape slot.
• Lower the presser foot and sew a few stitches until the right-
hand needle catches the left-hand edge of the tape.
• Loosen the setscrew (A) and adjust the tape guide to suit the
width of the tape (B).
• Retighten setscrew.
• Raise the tip of the power foot and place work underneath,
Sew.
Thread breakage during sewing
Sew off immediately at an angle and remove the work. Rethread.
If the lowe
r looper thread has broken, cut off both needle threads
npicking seams
sing sharp scissors cut the loops (C). Pull the needle thread
3
at the needle and remove the thread. First thread the looper and
then the needle. Start sewing again about 2-3 cm in front of
where the thread broke.
U
U
(D) and the stitches will come undone.
2
To Next Page
Loading...
Need help?
General
