Using the machine
Two-step presser foot lifter
To raise the presser foot, raise the presser foot lever on the
rear of the machine, until it engages (A). It can be raised
again to maximum height and held in this position to provide
more space between presser foot and stitch plate (B).
Changing the presser foot
• Turn power switch to “O”
• Raise the presser foot
• Turn handwheel towards you until needles are fully
raised.
Press the catch (C) to release the presser foot from the
clamp. Raise the presser foot to the highest position (B)
and remove the presser foot to the left. To attach the
presser foot, place it under the shaft. The groove in the
shaft should line up exactly with the presser foot pin
(D). Lower the shank and the presser foot will engage
automatically.
8
To Next Page
Loading...
