Threading
3. Right-hand wheel needle, green markings
Place the spool on the spool holder pin underneath the green
marking on the thread guide.
(1,2) Bring thread up from spool and take it through the
green guides.
(3,4) Make S-loop around the thread guide bar.
(5) Thread tension dial.
(6,7,8) Thread guides.
(9) Thread guide on needle clamp.
(10) Turn the handwheel towards you until the needles are
fully raised. Thread the right-hand needle.
(11) Raise the presser foot, place thread underneath it. Lower
presser foot.
13
To Next Page
Loading...
