Maintenance
Changing the upper knife
The upper knife (moving knife) is made from special
hardened material. Should it get damaged, it can be replaced
by your local Bernette dealer.
Changing the lower knife
• Disconnect machine from electricity supply.
• Turn handwheel towards you until needles are
fully raised.
• Raise the upper knife
Loosen the setscrew on the lower knife retaining plate.
Remove the lower knife. Fit the replacement knife
(from accessory bag) in the groove so that the sharp is
in line with the stitch plate. Retighten the screws (see
page 1).
Replacing the bulb
• Disconnect machine from electricity supply.
Unscrew the bulb and replace it with a new one: The bulbs
are 15 Watt for 110V/115V machines and 10 Watt for
220V/230V/240V machines. They are available from your
local dealer.
Cleaning and lubricating
• Disconnect machine from electricity supply.
During sewing, dust and fluff collect in and on the machine.
This should be removed regularly. Your Funlock requires
very little lubrication. Now and then, lubricate only the
points illustrated (see page 1).
24
To Next Page
Loading...
Need help?
General
