3
CHECKS AND MAINTENANCE
34
GB
AIR FILTER
To access the filter:
- Remove screw A and remove the sad-
dle in the direction B indicated in the
figure
- Remove the filter box cover
- Remove screw E and pull out the filter
Sponge filter (Enduro, Enduro
Factory)
- wash the filter with soap and cold
water
- Dry the filter
- Wet the filter with filter oil, removing
any excess oil so that there is no drip-
ping; we suggest to grease the side
that touches the filter box.
Paper filter (Motard, Trak, En-
duro standard)
- Blow the filter with compressed air.
- If necessary also clean the interior of
the filter box
- Reassemble proceeding in the reverse
order.
NOTE:
If the filter is damaged, replace it im-
mediately.
WARNING:
After every intervention, check that noth-
ing has been left inside the filter box.
Clean the filter every time the
vehicle is used cross-country.
Important for the FACTORY
version:
If used on the race track, clean the air
filter after each race.
B
E
A
To Next Page
Loading...
Need help?
General
