3
CHECKS AND MAINTENANCE
37
GB
LIQUID COOLANT
The level check must be performed with
the engine cold, as follows:
- Hold the motorcycle vertical to the ground
- remove the cap A and check that the
level of the liquid covers all the radiator
elements. If it does not, add liquid until
all elements are covered.
WARNING:
To avoid burns, never unscrew the radiator
filler cap when the engine is hot.
Check that breather pipe B is not kinked.
Note:
The FACTORY version is equipped with a
dual radiator.
Note:
The circuit capacity of the Factory version
is 850cc, while for all other versions, it
is 500 cc. Use the fluids specified in the
table on page 26.
A
B
OPERATIONS AFTER CLEANING
After washing the motorcycle:
- push handlebar control protections back so any penetrated water can evaporate.
- lubricate all pour points and working points.
- clean the chain.
- treat all plastic and powder coated parts with specific non-aggressive detergents
and products for the care of the vehicle.
- to avoid electrical problems, treat electrical contacts and switches with electrical
contact spray.
To Next Page
Loading...
Need help?
General
