K44 Technical manual 17
Standard mode or advanced
When K44 is delivered, the code lock is set to
standard mode. This means that 4 four-digit
codes can be programmed. If set to advanced
mode, you can program 20 four-digit and 10
six-digit codes.
This is how to set K44 to advanced mode:
1 Press B and enter the password.
2 Enter A99. Á
3 Enter 1.
4 Press B to leave programming mode.
To reset K44 to standard mode, enter 0 in step
3 instead.
Erase the memory
This is how to erase all programmed
information (including the password):
1 Press B and enter the password.
2 Press SW1 on K44 circuit board.
3 Enter 112186.
4 Enter 112186 once again. The memory is
now erased and K44 goes back to the
factory settings.
To Next Page
Loading...
