K44 Technical manual 9
Programming
Before you start programming K44 it might be
a good idea to make a note of the codes to
program and to which timing group they
should belong. On the inside cover you will
find a chart designed for this purpose. When
programming, look at your notes and follow
the instructions below.
Buzzer and LEDs
During programming you will be guided by
the buzzer and the LEDs.
In programming mode before a function is
chosen: The buzzer sounds with short beeps
during which both LEDs.
During programming: The beeps come in
shorter intervals. The LEDs are lit, off or
flashes depending on the function being
programmed.
Correct instruction: Confirmed by a rising
signal consisting of two quick beeps.
Faulty instruction: Confirmed by a falling
signal consisting of two quick beeps.
To Next Page
Loading...
