6. Pre-print checks
It is that all pre-print checks are carried out before starting a print on the 3D touch. This section of the manual guides the user throughessential
these checks:
a. Clearing the print bed
b. Check the print bed is fitted correctly
c. Power up
d. Test all axes
e. Check the hot-end nozzles are clean from plastic debris
f. Check the print bed is level
g. Check the bed is referenced to the extruder nozzles
h. Load the extruders
i. Extruder control
j. Purge the extruder
k. How to start a print
l. Print a successful raft
To Next Page
Loading...