f. Adjusting the nozzle wipe
The nozzle wipe should sit slightly higher than the height of the nozzle tip, so that when the nozzle is moved over the wipe, the wipe brushes over
the nozzle tip.
Use 'Manual move' to position the nozzle over the nozzle wipe box.
To adjust the height of the nozzle wipe, remove the nozzle wipe box and loosen the M3 nuts and bolts on the back of the wipeusing the
2.5mm hex driver supplied in the toolkit. Use the reference holes togauge the adjustment, and ensure that the nozzle wipe is horizontal.
Retighten the M3 nuts, replace the nozzle wipe box and re-check nozzle wipe position.
To Next Page
Loading...