Purge deposit
Perfect the raft
If analysis of the raft check file yields any problems, you will need to re-examine some of the setup stages:
Error Corrective action
Nozzle too high
See to adjust the height at which theg. Check the bed is referenced to the extruder nozzles
nozzle starts printing.
Nozzle to low
See to adjust the height at which theg. Check the bed is referenced to the extruder nozzles
nozzle starts printing.
Nozzle heights appear inconsistent across a
single print
See f. Check the print bed is level
Track ripping
See e. Check the hot-end nozzles are clean from plastic debris
Purge deposit
See e. Check the hot-end nozzles are clean from plastic debris
To Next Page
Loading...