Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail: bibo@ourbibo.com
Push the glass plate to the bolts on the two rear clamps in the back of aluminum
heated bed and press it down to install it . Let the glass plate be well contacted
with aluminum heated bed by pressing the sides of glass plate as the photo
below:
Please also check the glass bed whether can be easily moved in horizontal
direction.
2. Start the machine to see the main menu and touch the “Home” button
3. Now move the extruders to the right side first, and use your fingernail to
touch the “Z” button to run the Z axis homing. If touch “all”, the extruders will
be locked and you can’t move it, and the following leveling step can’t be done.
You can restart the printer and touch “Z” again to home Z axis.
Move extruders’ nozzles to be up on heated bed slowly. If nozzles can be
moved on heated bed (even the nozzles knock the bed and a little below the
To Next Page
Loading...