Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail: bibo@ourbibo.com
bed but still can move on the bed), then you can go to the second step to
load the filament first.
If nozzles can’t be moved on heated bed as they are below heated bed glass a
lot, the video instruction is here:
https://drive.google.com/file/d/12BrsKYa6_Yj4E5fzE3rCPnxrbGgEIkqr/view?usp=
sharing
You should do the following steps to level the bed as below:
Put a paper such as a A4 paper on the glass plate,
Rotate three wing nuts Clock-wise to let the glass bed down and nozzles can
move on the paper. If the nozzles still can’t move above the glass bed, please
check the file named “leveling problem Bend and move the Z axis limit switch” in
the troubleshooting file in the SD card sent with the printer.
To Next Page
Loading...