Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail: bibo@ourbibo.com
4. First Print
The first step is Leveling the heated bed(not necessary).
After transportation, only a few printers’s beds have to be leveled to ensure
your 3D prints stick well to the heated bed. How to check whether you have to
level your heated bed or not, please follow steps below.
1.Put the glass plate on the aluminum heated bed (two ways).
Some printers don’t have four clips sent with the printer, but with two
clamps fixed on the backside of the heated bed. If so, the fixed way is
below:
Four clips to fix the glass bed in front
and back side. Please open the clip first
then fix it on or remove it, or the clip
may scratch the circuit in the bottom of
the heated bed .
To Next Page
Loading...