Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail: bibo@ourbibo.com
4.Please put the printer center on a level table, not the edge of table. The printer
may be moving during fast speed printing especially for smooth desktop. So
please let the printer be horizontal, and have good friction to the desktop.
5.SD card may not be detected when you insert it to the printer which is power on,
you can refresh it or power off the printer and restart the printer.
6.When start the printer, you will hear the voice “zhi” of motor lock. It is
normal, the voice will disappear after some time.
7. When the printing is done, please do not turn off the printer at once until the
nozzle temperature be under 50 degree Celsius, or the extruder may be jammed.
When you stopped the printing through touch screen, the nozzles’ temperature
may be held and extruder fans will be always running in that case. If you want to
continue to print, it is ok for you to save printing time without heating again. If you
don’t want to print any more, you can turn off the printer then power on it again,
waiting the nozzle temperature be under 50 degrees.
8. When you start the printing, the touch screen will show you the nozzle’s target
temperature, but the nozzle’s actual temperature come down even to room
temperature. Please don’t worry, the printer will heat the bed first. After bed
temperature comes to the target temperature, the nozzle will start to be heated
and its temperature will rise up to the target temperature. During heating,
operation on the touch screen may not be valid or the screen be dead. You can
wait the heating ended to operate or power off the printer and power on again
to solve this problem.
9.If you want to print flexible filament, Best material to choose for our machine is
PLA flexible 1.75mm or TPU 1.75mm, and setting slow speed for both printing
speed and retraction speed to be 20-30 mm/s.
10. When printing, please don’t insert usb cable, or the printing will be paused for
a while then continued. It will affect the printing quality. Please also don’t let the
printer be connected with other devices by usb cable, or the touch screen may be
not responsive.
To Next Page
Loading...