Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail: bibo@ourbibo.com
11. In summer, the room temperature will become high, so we suggest you to
make sure the printing condition under 30 degrees. If the room temperature is
warm and there is no wind, you can also try printing without the acrylic cover.
12. There is some u disk can’t be detected by the printer when inserted. You can
insert the u disk then restart the printer, then it will work. Meanwhile in the settings
menu on touch screen there is the option for SD or U disk. Please choose U disk if
you want to print from U disk.
13. When you pause the printing and want to change the filament for both
extruders, please change filament for the other extruder first, then change
filament for the former printing extruder when paused, or the printing will switch
both extruders as changing (extruding) filament for the other extruder before
resuming the printing will activate this extruder and let this extruder print when you
resume the printing.
14. Please note that our heated bed Max. temperature is 100 degree Celsius
when the printer is in the enclosed room (room temperature 30 degree celsius),
and the printer should be enclosed too. If you set the bed temperature above 100
degrees, the printing will be failed.
To Next Page
Loading...