Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail: bibo@ourbibo.com
If there is warping or first layer not sticking, please use more glue and
higher bed temperature, or printing nozzle a little closer to the bed;
If there is shifted layers or prints are leaning, please lower the speed, or
check the belt pulley is tight enough to the rod and belt in suitable tension.
Now you can load the object first. click the “Object Placement” tab, and click
“Load” in the left or “+” in the right. Then choose the object you want to print.
For object you want to print can be downloaded free from
http://www.thingiverse.com/ or https://www.youmagine.com/
To Next Page
Loading...