BL-M22EP-0119 - 01-11-2019 1-1
SECTION 1
DESCRIPTION
1-1. INTRODUCTION.
This publication describes the 12 volt M22 lift truck
distributed by Big Lift LLC. Included are operating
instructions, planned maintenance instructions, lubri-
cation procedures, corrective maintenance procedures
and a complete parts list with part location illustrations.
Users shall comply with all requirements indicated in
applicable OSHA standards and current edition of
A.N.S.I. B56.1 Part II. By following these requirements
and the recommendations contained in this manual,
you will receive many years of dependable service
from your M22 lift truck.
1-2. GENERAL DESCRIPTION.
The manually-propelled M22 truck, Figure 1-2, lifts and
transports payloads up to 2200 pounds on adjustable
forks.
The handle is used to control the lift truck. The control
handle is used to propel and steer the lift truck. Lift
and Lower are controlled by a lever located near the
operator.
The model number will be found on the name plate
(Figure 1-1) along with the serial number, lifting capac-
ity, and load center. Figure 1-2 shows the locations of
the truck’s main components and controls.
1-3. SAFETY FEATURES.
The M22 is designed and engineered to provide maxi-
mum safety for operator and payload. Some of the
safety features incorporated into the design are:
Figure 1-1 Name Plate
• Foot actuated floor lock.
• Positive steer tracking caster.
• Lift control automatically returns to “OFF” when
released.
• High visibility color scheme of truck provides visual
alert of truck’s presence.
• Battery Discharge Indicator (BDI).
• Key switch.
To Next Page
Loading...
