Billion BiPAC 8520 - Factory Default Settings

Factory Default Settings
Before conguring your router, you need to know the following default settings.
Web Interface (Username and Password)
Username: admin
Password: admin
The default username and password are “admin” and “admin” respectively.
Device LAN IP settings
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site
PPPoE
DHCP server
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown in
the tale.
LAN Port WAN Port
IP address 192.168.1.254
The PPPoE function is enabled
to automatically get the WAN
port conguration from the ISP.
However, you have to set the
username and password rst.
Subnet Mask 255.255.255.0
DHCP server function Enabled
IP addresses for distribu-
tion to PCs
100 IP addresses continuing
from 192.168.1.100 through
192.168.1.199
25