Billyoh APEX - Fixing the Gutter Strips; Fixing Casement Stay; Automatic Opening Vent; Silicone Seal Building

S45
S45
28) FIXING CASEMENT STAY: (Opening Window Only)
12mm & 25mm
Screws
Philips
Screwdriver
S12
S12
S25
S25
Casement Stay Pins
Fix the WINDOW CASEMENT STAY (CS01) to the inside of the opening window with
12mm screws (S12) and it’s receiving bracket to the ROOF FRAME. Then Fix the
Casement Stay pins with 25mm Screws (S25). Ensure when the arm is engaged the
Pins securely holds the window in both open and closed positions.
Use a high quality silicone sealant to water proof the building. This is mainly needed on
1) theridge line of the roof and 2) where the roof sections join.
1
2
2
28) SILICONE SEAL BUILDING: (Silicone not supplied)
29) INTERNAL CLOAKING:
At the top of the where the side panels and roof panel panels meet a CLOAK STRIP PANEL
(CSP) is xed with 30mm nails (N30). These strips t between the TRUSS (TRU)
NOTE: Blunt nail points before xing to help prevent wood splitting.
50mm
Screws
30mm
Nails
Hammer
N30
N30
N30
50mm
Screws
30mm
Nails
Hammer
25) FIXING THE GUTTER STRIPS:
Fix one of the WINDOW SILL (1172mm) (WS) on each of the gable apex. Slot them in to the
groove of the ROOF PANEL and x in place with 30mm nails (N30) to allow water to run o
the front and back of the building. The window sill will need to be trimmed for ush t.
N30
ROOF PANEL
GABLE
PANEL
WS
GUTTER
N30
N30
N30
N30
25mm
Screws
Philips
Screwdriver
AVA
Use 25mm screws (S25) to x the AUTOMATIC VENT OPENING ARM (AVA) to the
OPENING WINDOW and the ROOF PANEL.
27) AUTOMATIC OPENING VENT: OPTIONAL EXTRA