MAIN MENU
Technical Help – Please contact the helpline on 0844 557 9677 20
7) Frequency setup
Press down button to select Frequency menu, then press OK button, and then
press Up or Down button to select light frequency “50Hz” or “60Hz” , then press
OK button to confirm your selection and return to the menu.
When your dash camera working under the light, please make sure what
frequency of the light and set your device accordingly.
8) Flash setup
Press down button to select Flash menu, then press OK button, and then press
Up or Down button to select LED light “On” or “Off”, then press OK button to
confirm your selection and return to the menu.
You can use ON/OFF button to turn LED light ON or OFF also. When the device
in video mode, press ON/OFF button, the flash light will be turn on, press again,
the flash light will be turn off.
9) Format
You can use this function to format your micro SD card.
Press down button to select Format menu, then press OK button, and then press
Up or Down button to select “Cancel” or “OK”, then press OK button, the mode
will be save. If you selected “OK”, the Micro SD card will be format, all data will
be deleted.
Note, insert a new micro SD card into your device, please format first.
10) Default setting
Use this function to return your dash camera to it’s original default factory settings.
Press down button to select Default setting menu, then press OK button, and
then press Up or Down button to select “Cancel” or “OK”, then press OK button to
confirm.
If you selected “OK” and confirmed, device will be return to default setting.
If your device hung up or working not good, you can default it.
To Next Page
Loading...