To Next PageTo Next PageWhy is my Binder Climate chamber not working?
Your Binder Climate chamber might not be working due to several reasons. First, check the connection to the power supply. Second, the chamber fuse might have responded, so check it and replace it if needed. If it responds again, contact BINDER service. Finally, the controller could be defective, in which case you should also contact BINDER service.
What to do if Binder 9010-0082 set-point temperature is not reached?
If the set-point temperature isn't reached in your Binder Climate chamber, ensure the chamber door is completely closed. Also, inspect the door gasket and replace it if it’s defective. Calibrate and adjust the controller. Finally, check the power supply to ensure the voltage is correct (115V or 230V).
Why Binder Climate chamber doesn’t heat up but controller display working?
If your Binder Climate chamber isn’t heating up, and the red heating control light is off but the controller display is working, it could be due to the timer being run off. Program the timer or switch to continuous operation. Another cause might be a defective semiconductor relay, in which case you should contact BINDER service.
What to do if Binder 9010-0082 isn't working and the red alarm light is on?
If your Binder Climate chamber isn't working and the red alarm pilot lamp is lit, it could be that the safety device class 2 has turned off the chamber. Let the chamber cool down and then press the RESET button. Also, the safety device class 2 might be defective, in that case contact BINDER service.
Why is my Binder 9010-0082 heating permanently?
If your Binder Climate chamber is heating permanently and not maintaining the set-point, the controller may be defective, in that case contact BINDER service. Alternatively, the controller might need calibration and adjustment.
How to fix high temperature and red alarm on Binder Climate chamber?
If the temperature inside your Binder Climate chamber is too high and the red alarm light is on, the safety device class 3.1 may have been triggered. Check the settings of the temperature set-point and of the safety device class 3.1.
Why does my Binder Climate chamber take longer to heat up?
If you're experiencing deviations from the indicated heating-up times with your Binder Climate chamber, it might be because the chamber is fully loaded. Try loading the chamber with fewer items or allow for longer heating-up times.
Why is my Binder 9010-0082 in stand-by mode?
If your Binder Climate chamber is without function and only the green 'stand-by' LED is lit, the chamber is likely in stand-by mode. Press the ON/OFF button until the display lights up.
What to do if Binder 9010-0082 fan is not working?
If the fan in your Binder Climate chamber isn’t turning or is turning too slowly, the fan might be defective, in that case contact BINDER service.
Why does my Binder 9010-0082 controller return to normal display?
If the controller on your Binder Climate chamber returns to the Normal Display from any level, it's likely because no button was pressed for approximately 30 seconds. Repeat your entries, entering the values more rapidly.
General| Brand | Binder |
|---|---|
| Model | 9010-0082 |
| Category | Climate chamber |
| Language | English |
Explains safety definitions, symbols, and legal aspects for safe operation.
Details the chamber's external components and controls.
Procedure for checking the chamber upon delivery.
Guidelines for safely handling and moving the chamber.
Specifies requirements for the installation site and ambient environmental conditions.
Steps for powering on the chamber and operating controller functions like set-point and time.
Covers chamber options, maintenance, cleaning, decontamination, and disposal procedures.
Addresses common faults, solutions, technical specifications, and equipment lists.
Includes conformity certificates, product registration, and contamination clearance forms.
