VAP 1 / VAP 2 06/2020 Page 10/52
DANGER
Electrical hazard by water entering the device.
Deadly electric shock.
∅ The device must NOT become wet during operation, cleaning, or maintenance.
∅ Do NOT install the device in damp areas or in puddles.
Set up the device in a splash-proof manner.
The devices were produced in accordance with VDE regulations and were routinely tested in accordance
to VDE 0411-1 (IEC 61010-1).
During and after operation the motor housing becomes hot. Avoid touching the hot motor housing when
operating the pump, especially when using the on/off switch.
CAUTION
Danger of burning by touching hot areas during or after operation.
∅ Do NOT touch the motor housing during and adjacent areas operation, especially when
using the on/off switch.
Figure 3: Hot areas on the vacuum pump
To Next Page
Loading...