VAP 1 / VAP 2 06/2020 Page 29/52
After using the disinfectant spray, allow the device to dry thoroughly, and aerate it sufficiently.
8. Maintenance and service, troubleshooting, repair, testing
8.1 General information, personnel qualification
The pump and connections must be checked daily during operation (chap. 6.1).
• Maintenance
See chap. 8.4.
• Simple troubleshooting
Chap. 8.3 describes troubleshooting by operating personnel. It does not require technical intervention
into the device, nor disassembly of device parts.
For personnel requirements please refer to chap. 1.1.
• Detailed troubleshooting
If errors cannot be identified with simple troubleshooting, further troubleshooting must be performed by
BINDER Service or by BINDER qualified service partners or technicians.
• Repair
Repair of the device can be performed by BINDER Service or by BINDER qualified service partners or
technicians.
After maintenance, the device must be tested prior to resuming operation.
• Electrical testing
To prevent the risk of electrical shock from the electrical equipment of the device, an annual repeat
inspection as well as a test prior to initial startup and prior to resuming operation after maintenance or
repair, are required. This test must meet the requirements of the competent public authorities. We
recommend testing under DIN VDE 0701-0702:2008.
Contamination of the device by toxic, infectious or radioactive substances must be prevented.
Components in contact with the medium can be contaminated by accidentally aspirated hazardous
substances (toxic, infectious, or radioactive material). They must be decontaminated before further
operation, maintenance and service, troubleshooting, repair, or tests. If appropriate, further protective
measures must be taken.
WARNING
Danger of intoxication and infection through contamination of the chamber with
toxic, infectious or radioactive substances.
Damages to health.
Make sure that NO toxic, infectious or radioactive material has been aspirated.
Take suitable protective measures when removing accidentally
aspirated toxic,
infectious or radioactive material as well as for any necessary decontamination of pump
components in contact with the medium
To Next Page
Loading...