VAP 1 / VAP 2 06/2020 Page 20/52
3.4 Guidelines for safe transportation
After operation, please observe the guidelines for temporary decommissioning (chap. 9.2).
You can order transport packing for moving or shipping purposes from BINDER service.
Ambient conditions
• Permissible ambient temperature range during transport: 10 °C / 14 °F to +60 °C / 140 °F.
• Permissible ambient humidity during transport: below 90 % r.h., non-condensing
3.5 Storage
Intermediate storage of the device is possible in a closed dry and low-dust room. Observe the guidelines
for temporary decommissioning (chap. 9.2).
Place the protective caps (chap. 3.1) on the suction and pressure connections. If they are no longer
available, another suitable protection can be used.
Ambient conditions
• Permissible ambient temperature range during storage: +5 °C / 41 °F to +40 °C / 104 °F.
• Permissible ambient humidity: below 90 % r.h., non-condensing.
When after storage in a cold location you transfer the device to its warmer installation site, condensation
may form. Before start-up, wait at least one hour until the device has attained ambient temperature and is
completely dry.
3.6 Location of installation and ambient conditions
Set up the device on a flat, even surface, and in a well-ventilated, dry location and align it using a spirit
level. The site of installation must be capable of supporting the chamber’s weight (see technical data,
chap. 10.1). The chambers are designed for setting up inside a building (indoor use).
NOTICE
Danger of overheating due to lack of ventilation.
Damage to the device.
∅ Do NOT install the device in unventilated recesses.
Ensure sufficient ventilation for dispersal of the heat.
Observe the prescribed minimum distances when installing the device.
Do not install or operate the device in potentially explosive areas.
DANGER
Danger of explosion due to combustible dusts or explosive mixtures in the vicinity
of the device.
Serious injury or death from burns and / or explosion pressure.
∅ Do NOT operate the device in potentially explosive areas.
KEEP explosive dust or air-solvent mixtures AWAY from the vicinity of the device.
To Next Page
Loading...