Binder VD 56 - 8.5 Activating; deactivating temperature control

VD (E3.1) 03/2020 page 59/173
8.5 Activating / deactivating temperature control
8.5.1 RD4 controller
Path: Normal display Temperature control
Press the OK button to enable the setting.
Setting the “Temperature control” function.
Use the arrow buttons to select between “On” (temperature control
active) and “Off” (temperature control deactivated).
Confirm the setting with the OK button.
On
After confirming with the OK button or with the Back button you go back to Normal display.
If the setting “Off” (temperature control deactivated) has been selected, the information message
“Temperature control off” is displayed. The „Info“ icon flashes slowly.
The actual temperature value continues to be displayed in Normal display.
8.5.2 MB2 controller
Press the Setpoint setting icon to access the “Setpoint” setting menu from Normal display..
Path: Setpoint > Control on/off
“Setpoints” menu.
Select the field “Control on/off” (example: deactivated
temperature control).
Mark / unmark the “Temperature” checkbox to activate /
deactivate temperature control and press the Confirm
icon.
• Checkbox marked: temperature control active
• Checkbox unmarked: temperature control deactivated