Standard seat post
To attach the seat to the seat post by first you must loosen the nuts on the seat clamp. Insert the tapered end of the seat post into the seat clamp
until it’s at the top of the clamp. Tighten the nuts onto the seat clamp, insert the seat assembly into the frame of the bicycle, and then adjust the seat
to the appropriate height. The seat post must be inserted to at least the “Minimum Insertion” line. Move the quick release lever to the closed
position. Adjust the seat to be centered in the clamp and parallel to the ground, then tighten the clamp nuts evenly before riding. Do not ride the bike
with a loose seat.
Micro-adjustable seat post
Loosen the seat fixing bolt, then slide the seat into the clamp. The two seat rails should fit into the clamp channels. There normally is no need to
remove the fixing bolt, but it may be necessary in some cases. Tighten the seat fixing bolt accordingly, then insert the seat assembly into the frame of
the bicycle and adjust the seat to your preferred height. The seat post must be inserted to at least the “Minimum Insertion” line. Move the quick
release lever to the closed position. You should feel resistance while moving the lever. If not, re-open and tighten the lever, then move it to the closed
position. Adjust the seat to be centered in the clamp and parallel to the ground, then re-tighten the seat fixing bolt before riding. Do not ride the bike
with a loose seat.
To Next Page
Loading...