28
How To Replace the Pedal Shaft
(Left & Right is based on sitting on the bicycle)
1.) Remove the plastic pedal arm cover, that covers the center shaft and nut and remove the nut and pull arm off of the shaft. Make note of distance
inner ring sticks out from outer ring to be used later for reassembly.
2.) Turn larger outer ring counterclockwise and remove from inner adjustment ring
3.) Remove inner bearing adjuster ring and remove inner bearing set
4.) Perform steps 1-3 for the right side
5.) Remove center shaft. Before reassembly grease bearings and inner bearing races with high grade grease.
6.) Replace new part with one that was needed replaced and reassemble in reverse order. Install left section first and set the distance recorded
from last part of step 1.
7.) Install the right side inner ring to bearing pressure by turning clockwise until stiffness while rotating the shaft and back off screw 1/8" turns out
counterclockwise. (One rotation equals one full turn, and 1/2 turn would be equal to from 12 o'clock to 6 o'clock. A 1/4 would be 15 min position,
and 1/8 position would be equal to 5-7 min on clock.)
8.) Install both arms and nuts and covers.
To Next Page
Loading...