6
Safety Checklist
Before first initial ride and every ride after, it is important to carry out the following safety checks:
1.
Brakes
•
Check that front and rear brakes work properly.
•
Check that brake calipers are not over worn and are adjusted correctly.
•
Check that brake control cables are lubricated, adjusted, and do not display obvious wear and tear.
•
Check that brake control levers are lubricated and tightly secured to the handlebar.
2.
Wheels & T ires
•
Check that tires are inflated within the recommended limit as displayed on the tire sidewall.
•
Check that tires have tread and do not show any bulges or excessive wear.
•
Check that rims run true and do not have any obvious wobbles or kinks.
•
Check that all wheel spokes are tight and unbroken.
•
Check that axle nuts are tight. If your bicycle is fitted with quick release axles, make sure locking levers are correctly tensioned and in the closed position.
3.
Steering
•
Check that the handlebar and stem are correctly adjusted, tightened, and allow proper steering.
•
Check that the handlebars are set correctly in relation to the forks and the direction of travel.
4.
Chain
•
Ensure chain is oiled, clean, and runs smoothly. (Extra care is required in wet or dusty conditions)
5.
Bearings
•
Check that all non-sealed bearings are lubricated, run freely, and do not display excess movement.
6.
Cranks & Pedals
•
Check that pedals are tightened to the cranks.
•
Check that cranks are tightened to the axle and are not bent.
7.
Derailleurs
•
Check that the front and rear mechanisms are adjusted and function properly.
•
Check that the shift and brake levers are attached to the handlebar, shift, and brake.
•
Check that derailleurs, shift levers, shift and brake cables are properly lubricated.
8.
Frame and Fork
•
Check that the frame and fork are not bent nor broken. (If either is bent or broken, they need to be replaced)
9.
Accessories
•
Check that that all reflectors are properly fitted.
•
Check that all other fittings on the bike are properly secured, fastened, and functioning properly.
•
Make sure the rider is wearing a helmet.
10.
Motor and Throttle
•
Check that the motor is working properly.
•
Check that the throttle is working properly.
11.
Battery pack
•
Check that the batteries are in good operating condition and kept fully charged.
To Next Page
Loading...