21
Checking Battery Terminals
If the battery is not charging properly, follow these steps:
1.) Remove the battery pack from the bike
2.) Remove the cap from end of the battery that has four slots
3.) Remove cover plate
4.) You are now able to look at the red and black wires. The two black wires should be on the same side as the key.
5.) If the Black wires are not on the side of the Key carefully open the Terminal Block Cover
*Note: if the Red and Black wires touch they may spark, keep them separate to avoid this.
6.) With the terminal block cover open, lift out the red and black wires to relocate them with the black pair on the same side as the key
7.) Close the cover on the terminal block
8.) Place the terminal block back into the cap, place the cover on the terminal block and install screws
9.) Re-install the cap onto the battery
10.) Charge the battery. Your battery should now be charging correctly.
To Next Page
Loading...