27
How To Remove the Rear Wheel
1.) Remove the four screws from the aluminum plate located on the lower left side of the bike – you will now have access to the controller and wires.
3.) Disconnect the three blue, yellow and green gauge wires
4.) You will see a six pin connector (only five wires), bend the retaining tab on the terminals to remove all five wires from the connector
5.) Be sure to install wires back into the connector in the proper location when reassembling
6.) Loosen the axle nuts and slide the wheel out of the frame.
7.) With the wire connector removed from the wires you can now remove the wheel assembly
To Next Page
Loading...