Biochrom Anthos Fluido-2 Microplate Washer v2.0 Page 23
7.2 Programming Sequence
The software offers the possibility to program up to 50 so-called
procedures (a procedure defines a complete wash program). To define a
procedure cycles (defines one part - cycle - of a wash program; e.g. bottom
wash) and plates (defines the shape and measures of the plate used) are
necessary.
Drawing
: Software Principle
Note: Please make sure to program the cycle and plate BEFORE the procedure!
7.3 Menus
The following flow diagrams give an overview of all menus and the way
of navigating through them. Detailed information for all menus and their
functions can be found in the following chapters.
For details please refer to chapter 9.1 Run Procedure
Run Procedure:
<< >> Proc1
To Next Page
Loading...
