Biochrom Anthos Fluido-2 Microplate Washer v2.0 Page 12
bottom of the well. This results in improved washing performance and
minimized residual volume without the manifold touching the bottom of
the well (with flat bottom plates only).
Wash cycles and procedures
Wash cycles: Up to 20 may be defined according to specific requirements
and are stored on the instrument. Once a wash cycle is created it may
be used in different wash procedures.
Some of the main features are:
• Bottom and Overflow washing
• Adjustable Dispense volume and speed
• Adjustable aspiration power and time
• Adjustable soak time
• Shaking (3 modes)
Wash procedures: Up to 50 may be created by putting up to 8 previously
defined wash cycles in sequence. Washing procedures can either be
performed step by step over the whole plate (PLATE-mode) or strip by
strip (STRIP-mode). The number of strips to be processed may be
defined at the time the wash procedure is started.
Options
Liquid level detectors to check volumes in wash and waste bottles.
Remote control software for PC:
Windows based software for programming of washing procedures and
plate configurations. The washer may be remotely controlled from the
PC to run the instrument in a Windows environment. Data may be
transferred between instrument and PC.
The combination of both platforms, the flexible onboard software and
the convenient Windows-based program gives the user the optimum
choice to operate the Fluido 2.
Software updates on the washer are performed conveniently from the
computer. Existing procedures or plate setups can easily be copied to
another unit without the need to go through the programming again.
4.5 Standard delivery content
Washer Fluido 2
external tubing set
Manifold (8-way)
1 or 3 wash bottles 2 L (depending on configuration)
Rinse bottle 2 L
Waste bottle 2.5 L
Power cord
To Next Page
Loading...