BM3 www.BIO2NET.com
Revision A
- 10 -
At least once a month, clean and wipe off the frame by using the soft cloth
after wetting it with lukewarm water and alcohol. Do not use lacquer, thinner,
ethylene, or oxides, which could be harmful to the Equipment.
Make sure both cables and accessories are free of dust or contaminants, and
wipe them off with soft cloth wetted with lukewarm water(40℃ / 104℉), and at
least once a week, clean them by using the clinical alcohol.
Do not submerge the accessories under any liquid or detergent. Also, make
sure any liquid not to penetrate into the Equipment or probe.
Caution!
Do not dispose single use probe to any hazard place, Always think about
environmental contamination
Caution!
There is back-up battery on board inside system. When users dispose this
chip. Please waste proper place for environmental protection
CR2032 3.0Volt battery
Warning: Check the electrodes of batteries
before changing them.
3. Performance Specification
Ease of use
• Battery operation
To Next Page
Loading...
