Biostar M6VLA - SB IRQ Select; SB DMA Select

Chapter 2 BIOS Setup
2-19
Sound Blaster
Hardware SoundBlaster Pro for Windows DOS box and real-mode
DOS legacy compatibility.
The Choices: Enabled, Disabled (default).
SB I/O Base Address
Change the SoundBlaster Pro Base I/O Address settings.
The Choices: 220H(default), 240H, 260H, 280H.
SB IRQ Select
Change the SoundBlaster Pro interrupt signal.
The Choices: IRQ5(default), IRQ7, IRQ9, IRQ10.
SB DMA Select
Change the SoundBlaster Pro direct memory access setting.
The Choices: DMA0, DMA1 (default), DMA2, DMA3.
MPU-401
Enable or Disable MPU-401 function.
The Choices: Enabled (default), Disabled.
MPU-401 I/O Address
Change the SoundBlaster Pro MPU-401 I/O address.
The Choices: 300-303H, 310-313H, 320-323H, 330-333H (default).
Game Port (200-207H)
Change the joystick connect port address.
The Choices: Enabled (default), Disabled.
Init Display First
This item allows you decide to active whether PCI Slot or on-chip VGA first.
The Choices: PCI Slot (default), AGP.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block mode
(most new drives do), select Enabled for automatic detection of the optimal
number of block read/writes per sector the drive can support.
The Choices: Enabled (default), Disabled