Biostar M6TSU User Manual

M6TSU
Federal Communications Commission
(F.C.C) Statement
This device complies with Part 15 of the FCC Rules. Operation of this device is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Accessories: This device has been tested and found to comply with the limits of a
Class B digital device, the accessories associated with this equipment are as
follows:
1. Shielded serial cable (Can be obtained from multiple retail outlets)
2. Shielded printer cable (Can be obtained from multiple retail outlets)
3. Shielded video cable (Can be obtained from multiple retail outlets)
4. Shielded power cord (Provided by manufacturer)
These accessories are required to ensure compliance with FCC Rules. It is the
responsibility of the user to provide and use these accessories properly.
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. There is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, you are
encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient / relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the manufacturer
could void the user’s authority to operate the equipment.

Biostar M6TSU Specifications

General

Onboard Audio	Yes
Supported CPU	Intel Pentium
Memory Type	SDRAM
Expansion Slots	1 AGP
IDE	2
Storage Interfaces	IDE

Summary

RAID BIOS Setting (Optional)

3.2 Installation of Driver

3.3 Use RAID Administrator

Explains how to install, run, and use the RAID Administrator for creating and managing RAID arrays.

3.4 BIOS Configuration

Details how to enter the BIOS configuration utility and perform RAID operations like create, delete, and rebuild.

Trouble Shooting

No power inputs to the system at all

System shows no power indication: no lights, no fan operation.

System is inoperative. Keyboard lights are on, power indicator lights are lit, hard drive is spinning.

System is inoperative but has power; keyboard and indicator lights are on, hard drive spins.

System does not boot from hard disk drive, can be booted from CD-ROM drive.

System fails to boot from the hard disk but boots from CD-ROM.

System only boots from CD-ROM. Hard disk can be read and applications can be used but booting from hard disk is impossible.

System boots from CD-ROM only; hard disk is readable but not bootable.

Error message reading “SECTOR NOT FOUND” or other error messages not allowing certain data to be retrieved.

Receiving 'SECTOR NOT FOUND' or similar errors when accessing data.

Screen message says “Invalid Configuration” or “CMOS Failure.”

System displays 'Invalid Configuration' or 'CMOS Failure' messages.

Screen is blank.

The display shows nothing; screen is blank.

Screen goes blank periodically.

Keyboard failure.

C: drive failure.

The primary system drive (C:) has failed.

Cannot boot system after installing second hard drive.

Missing operating system on hard drive.

Certain keys do not function.

Keyboard is locked, no keys function.