Chapter 3 Trouble Shooting
3-24
3.3.7 Create Span Array
Please follow the steps below to create the span array:
1. Click Span icon on the tool bar.
2. In the popup window, select hard disks from Available Disks column.
Add them into Span Array Member Disks column by clicking the
corresponding arrow. Then click Next to continue.
3. In the follow-on confirmation dialog box , please click Create button
to start the creation or click Cancel button to cancel the creation . If
the user selects Cancel, the system will remain unchanged.
4. After the create operation is complete, please shut down all other
programs. And then click Yes to restart the computer. The user may
also select No to restart the computer later.
Note:
At least two hard disks are needed in the creation of the span array. Disks
can be connected at any cable and set as either master or
slave device.
Warning:
In the creation of the span array, only the data on the first member disk
will be preserved while the data on others will be completely destroyed.
To Next Page
Loading...
Need help?
General
