Chapter 3 Trouble Shooting
3-34
3.4.2 Create RAID
The following steps shall be taken to create RAID in BIOS.
1. Use the arrow key to select 1. Create RAID.
2. Press Enter to confirm and go to next.
3. Select 1. Array Mode in the popup sub-interface and press Enter.
4. Select the intended RAID level in the popup selection box and press
Enter.
5. Select
2. Select Disk Drives
in the previous sub-interface and press
Enter.
6. Select the disks to be used for creating the disk array and press
Enter to confirm in the channel status zone.
7. Select 3. Start Creation Process and press Enter except that in the
selection box you have selected Stripping (RAID 0) for Performance.
8. Press Y to continue when the warning message appears.
Note:
1. If you have selected Stripping (RAID 0) for Performance in the
popup sub-interface after the operation of 1. Array Mode , you should
direct go to 3. Strip Size 64K and then select 4. Start Creation
Process . The default strip size is 64K .
2. Different warning messages appear according to different RAID levels.
To Next Page
Loading...
Need help?
General
