Chapter 3 Trouble Shooting
3-2
3.2 Installation of Driver
3.2.1 Introduction
After the computer start up, you shall install RAID driver.
3.2.2 Windows 98/ME
Automatic Installation
After the computer start-up, Windows system will find the newly installed RAID
adapter and ask you to install its driver. Please follow the prompt to finish the
driver installation.
Manual Installation
If Windows can not find new hardware, the driver can be installed through the
following steps :
1. Shut down all programs.
2. Click Start-->Setup-->Control Panel, then double-click on Add
New Hardware icon.
3. Click Next in the popup window to continue.”.
4. A dialog box will appear and ask whether to let windows search
new hardware. Select No,I want to select the hardware form a
list. Then click Next to continue.
5. Hardwares of different types will be shown in the follow-on window.
Select SCSI Controllers and then click Next to continue.
6. Insert the floppy disk of driver into the floppy drive, then click Have Disk....
7. A dialog box will pop up, input the path of driver A:\Win9X.Then
click OK to continue.
8. In the follow-on window, select HPT370 UDMA/ATA100 RAID Controller
then click Next to continue.
9. Follow the system prompt to install driver. When finished, restart
the computer.
To Next Page
Loading...
