Biostar M6VLA - Modem Use Irq; Soft-Off by PWRBTN

Chapter 2 BIOS Setup
2-23
PM Control by APM
No System BIOS will ignore APM when
Power Management is on.
Yes (default) System BIOS will wait for ROM’s prompt
before it enters any PM mode.
Video Off Option
This determines the manner in which the monitor is blanked.
Suspend -> Off
(default) During Suspend mode, the monitor will be
Turned off.
All Mode -> Off During All modes, the monitor will be turn
off.
Always On During Always mode, the monitor will be
Turn on.
Video Off Method
V/H SYNC+Blank (default) In addition to the above, BIOS will also
turn off the V-SYNC & H-SYNC signals
from VGA card to monitor.
DPMS supported This function is enabled only for a VGA
card supporting DPMS.
Blank Screen The system BIOS will only blank the
screen when disabling video.
MODEM Use IRQ
This determines the IRQ, which the MODEM can use.
3 (default)
4 / 5 / 7 / 9 / 10 / 11 / NA
Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off states when the system has “hung”.
The Choices:, Instant-Off (default), Delay 4 Sec.