Chapter 2 BIOS Setup
2-24
Wake Up Events
If you highlight the literal “ Press Enter” next to the “Wake Up Events” label and
then press the enter key, it will take you a submenu with the following options:
VGA When set to on, any event occurring at a
VGA port will awaken a system which has
been powered down.
The Choices: Off (default), On.
LPT&COM When set to On, any event occurring at a
VGA Port will awaken a system which has
been powered down.
The Choices: LPT/COM (default), COM,
, LPT, NONE.
HDD&FDD When set to On(default), any event
occurring at a hard or floppy drive will
awaken a system which has been powered
down.
The Choices: On (default), Off.
PCI MASTER
When set to On, any event occurring at
PCI will awaken a system which has been
powered down.
The Choices: Off (default), On.
Wake Up On LAN/Ring To use this function, you need a LAN
add-on card which support power on
function. It should also support the
wake-up on LAN jump.
The Choices: Disabled (default),Enabled.
RTC Alarm Resume When “Enabled”, you can set the date and
time at which the RTC (real-time clock)
alarm awakens the system from Suspend
mode.
The Choices: Disabled (default),Enabled.
Date (of Month) You can choose which month the system
will boot up.
To Next Page
