BIXOLON SRP-S320 User Manual

SRP-S300
Ver. 2.00
- 22 -
3-2 Turn on the Power
1) After turning the printer off, connect the power cord jack to the printer’s power port.
2) Plug it into the power outlet on the wall.
3) Press the “ON” switch to turn on the printer.
- Be sure to turn off the printer and connect or disconnect the cable.
- Only use a power supply provided by BIXOLON. BIXOLON shall
bear no responsibility for damage caused by using a third-party
power supply.
- Check the power supply’s label to check its electronic specs.
- When removing the power supply, make sure you have a firm
grasp of the plug terminal of the power jack and the printer
and pull horizontally.
- When connecting or disconnecting power, make sure to remove
the power supply from the power outlet before removing.
- Pay attention to the direction in which you insert the power jack.
- Do not connect a voltage out of the specifications of the power
supply. It can cause damage to the product or a fire.
Power Cord Jack
Power Port

BIXOLON SRP-S320 Specifications

General

Brand	BIXOLON
Model	SRP-S320
Category	Printer
Language	English