SRP-S300
Ver. 2.00
5. Self-Test
The self-test checks whether the printer has any problems.
If the self-diagnostics reveal no error in the printer, please see other device or software.
If the printer does not run normally, please contact the place of purchase.
- Do not open the top cover while the printer is running.
- If the printer does not run normally, please contact Customer
1) Check whether the paper is inserted correctly.
2) Turn on the power while holding down the FEED button and the self-test begins.
3) The self-test prints the current status of the printer including control ROM version.
4) The printer prints the current status and stops after printing the following statement.
(PAPER indicator keeps blinking.)
SELECT MODES BY PRESSING FEED BUTTON.
Continuous SELF-TEST : Less than 1 second
VMSM Selection : 1second or more
5) Press the FEED button for less than 1 second to perform “Continuous SELF-TEST”.
Hold down the FEED button for 1 second or longer to perform “VMSM Selection”
To Next Page
Loading...
Need help?
General
