Why is the amplitude double of what I set on my BK Precision 4055B?
The amplitude doubling often occurs because the impedance of the generator isn't matched with the oscilloscope. To resolve this, connect a 50 Ω terminator to the oscilloscope input, then use a BNC cable to connect the generator and the terminator, ensuring impedance matching.
How to troubleshoot power issues with my BK Precision Portable Generator?
First, check that the power cord is securely connected to the AC input and that your electrical AC outlet is providing live power. Also, verify that the AC power from the mains is the correct voltage for the generator.
What to do if there is no output from the terminals of my BK Precision 4055B Portable Generator?
Ensure that the Output buttons above channel 1 and/or channel 2 are illuminated. If they are not, press the button once to activate the output.
How to troubleshoot power up issues with BK Precision Inverter?
First, ensure the power cord is securely connected to the AC input and that the electrical AC outlet is providing live power. Also, verify that the AC power coming from the mains is the correct voltage for the BK Precision Inverter.
What to do if I cannot see any output out of the output terminals of my BK Precision Inverter?
Ensure that the Output buttons above channel 1 and/or channel 2 are illuminated. If they are not, press the button once to activate the output on your BK Precision Inverter.
General| Brand | BK Precision |
|---|---|
| Model | 4055B |
| Category | Portable Generator |
| Language | English |
Defines IEC 61010 safety category ratings for electrical environments.
Specifies power requirements and safety grounding procedures for instrument operation.
Lists environmental hazards and operational restrictions for safe instrument use.
Identifies and describes the components on the instrument's front panel.
Identifies and describes the connectors and ports on the instrument's rear panel.
Explains the different elements shown on the instrument's TFT-LCD display.
Details the voltage and frequency specifications for powering the instrument.
Guides on connecting outputs, impedance matching, and waveform integrity.
Outlines steps to verify the instrument's readiness for operation.
Navigating menus and selecting output channels for configuration.
Setting waveform shape, frequency, amplitude, offset, phase, duty cycle, and more.
Details configuring amplitude modulation parameters.
Details configuring frequency modulation parameters.
Details configuring phase modulation parameters.
Sets the duration and frequency range for sweep operations.
Configures burst output by cycles, continuity, or external gating.
Initiates self-diagnostic tests for instrument components.
Configures and utilizes the built-in frequency measurement tool.
Sets up USB, LAN, and GPIB for remote control.
Solutions for issues with powering on the instrument.
Troubleshooting steps when no output signal is observed.
To Next Page
