*ESR?
This command can read the value of standard event status register. After executing this
command, standard event status register is reset. Bit definition of standard event status register
is the same as the standard event status enable register.
Query syntax: *ESR?
Parameter: None
Returned parameter: <NR1>
*IDN?
This command can read information about power supply. The returns parameter contains 4
segments divided by comma.
Query syntax: *IDN?
Parameter: None
Returned parameter: <AARD> segment description
B&K Precision Manufacturer
9115 Product model
XXXXXX Product serial number
VX．XX –VX．XX Software version
Example: B&K Precision, 9115, 00000000000004, V1.01-V1.00
*OPC
When all commands before this command are executed, bit OPC in standard event register will
be set to 1.
Command syntax: *OPC
Parameter: None
Query syntax: *OPC?
Returned parameter: <NR1>
*RST
This command resets the power supply to default settings.
Command syntax: *RST
Parameter: None
*SRE
This command can set the parameter of state byte enable register. Setting parameter can
determine which byte value of state byte register is 1 and the byte will set RQS of state byte
register to 1. Bit definition of state byte enable register is the same as the state byte register.
Command syntax: *SRE <NR1>
Parameter: 0~255
Query syntax: *SRE?
Returned parameter: <NR1>
*STB?
This command can read the data from status byte register.
To Next Page
Loading...
Need help?
General
