Need help?Do you have a question about the BK Precision 9205 and is the answer not in the manual?
General| Output Current | 0 - 5A |
|---|---|
| Power Rating | 150 W |
| Load Regulation | < 0.01% + 3 mV |
| Line Regulation | < 0.01% + 3 mV |
| Over Voltage Protection | Yes |
| Over Current Protection | Yes |
| Output Voltage | 0 to 30 V |
| Display | LED |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -20°C to 70°C |
General safety precautions for operation, maintenance, repair, and explanation of safety category ratings (I, II, III, IV).
Requirements for accessory category rating, electrical power, and proper grounding procedures.
Restrictions on operating in flammable atmospheres and specific indoor environment requirements.
Specifications for operating environment limits and precautions for damaged instruments.
Instructions for cleaning, limitations for critical applications, and warnings about touching live circuits.
Warnings about internal voltages, fuse replacement procedures, and servicing guidelines.
Requirements for wire gauge and general safe use practices for the instrument.
Details on the 9200 Series power supplies, their features, and included items.
Identification and description of the front panel display, keys, and rotary knob.
Overview and description of the instrument's keypad buttons and their functions.
Identification and description of connectors and ports on the rear panel.
Details on AC input voltage, frequency, and required fuse specifications.
Step-by-step guide to check and change the line voltage switch and fuse for operation.
Guidelines for connecting loads to the output terminals, including wire gauge recommendations.
Steps to verify AC input voltage, connect power, and run a self-test. Includes self-test error messages.
Overview of menu sections including MAX VOLT, OCP SET, SYST SET, LIST SET, POWER INFO.
Step-by-step guide to set the desired output voltage using front panel controls.
Steps to set output current and details on remote sense setup.
Setting voltage limits and overcurrent protection (OCP) within the SYSTEM menu.
Detailed steps for configuring RS-232 settings like baud rate and parity.
Commands to set the output current level using various methods.
Commands to set the output voltage level using various methods.
Setting up and controlling the List mode for creating and executing sequences.
To Next Page