BK Precision 9205 User Manual

39
Return parameter: <NR1>
SYSTem:INTerface
This command is used to select the communication interfaces.
Command syntax：SYSTem:INTerface <GPIB|USB|RS232>
5.6 TRIGGER Subsystem
TRIGger[:IMMediate]
This command is used to create a trigger signal. It will give a trigger signal in BUS trigger source
mode. The function is the same as command *TRG.
Command syntax: TRIGger[:IMMediate]
Parameter: None
Related commands: *TRG
TRIGger:SOURce
This command is used to select the trigger source. Power supply can receive trigger signals
directly from front panel by pushing “Trigger” button or receive from a BUS trigger signal using
*TRG command.
Command syntax: TRIG:SOURce <mode>
Parameter: MANUAL|BUS
Query syntax: TRIGger:SOURce?
Return parameter: MANUAL|BUS
5.7 SOURCE Subsystem
[SOURce:]OUTPut[:STATe]
This command is used to control the output state of the power supply.
Command syntax: [SOURce:]OUTPut [:STATe] <bool>
Parameter: 0|1|ON|OFF
Query syntax: [SOURce:]OUTPut[:STATe]?
Return parameter: 0|1
OUTPut:TIMer
This command is used to set the state of the output timer.
Command syntax: OUTPut:TIMer[:STATe] <bool>
Parameter: 0|1|OFF|ON
Query syntax: OUTPut:TIMer?
OUTPut:TIMer:DATA
w ww . . co m
information@itm.com1.800.561.8187

BK Precision 9205 Specifications

General

Brand	BK Precision
Model	9205
Category	Power Supply
Language	English