BK Precision 9201 - IEEE488.2 SCPI Commands: Status and Control; Status and Identification Commands (*ESR?, *IDN?); Reset and Control Commands (*OPC, *PSC, *RST)

To Next Page

To Previous Page

DDE Device-dependent error

QYE Query error

OPC Operation complete

*ESR?

This command can read the value of standard event status register. After executing this

command, standard event status register is reset. Bit definition of standard event status register

is the same as the standard event status enable register.

Query syntax: *ESR?

Parameter: None

Returned parameter: <NR1>

*IDN?

This command can read information about power supply. The returns parameter contains 4

segments divided by comma.

Query syntax: *IDN?

Parameter: None

Returned parameter: <AARD> segment description

Manufacturer, Model, Serial number, Software version

Example: B&K Precision, 9205, 602203010697410001, V1.09-V1.04

*OPC

When all commands before this command are executed, bit OPC in standard event register will

be set to 1.

Command syntax: *OPC

Parameter: None

Query syntax: *OPC?

Returned parameter: <NR1>

*PSC

This command controls whether the power supply sends a query or not when it is reset. If set to

1 or ON, the operation event enable register, quest event enable register, and standard event

status register will be reset when power supply is reset. When set to 0 or OFF, the data of the

status byte register, operation event enable register, quest event enable register and standard

event status enable register will be stored in non-volatile memory and recalled when power

supply is reset.

Command syntax: *PSC <bool>

Parameter: 0|1|ON|OFF

Query syntax: *PSC？

Returned parameter: <NR1>

*RST

This command resets the power supply to default settings.

Command syntax: *RST

w ww . . co m

information@itm.com1.800.561.8187

BK Precision 9201 - IEEE488.2 SCPI Commands: Status and Control; Status and Identification Commands (ESR?, IDN?); Reset and Control Commands (OPC, PSC, *RST)