12 BK Radio
ALPHANUMERIC DISPLAY
The G Series portable radios are built with one of the
following display options:
• No keypad and no display or
• Keypad and alphanumeric display
With obvious exceptions, the operational procedures
are the same for both these radios.
Radios with a keypad and display have a slide-out
keypad cover. To remove or install the cover, turn off
the radio and remove the battery (see Battery
Installation and Removal, page 28).
Radios with alphanumeric displays can be
programmed to operate one or more channel groups.
DISPLAY BACKLIGHTING
The GPH radios can be programmed by your dealer
to backlight the display when a signal is received or
when a key is pressed. The time duration of the
backlighting can also be programmed.
CHANNEL LABELS
You can program the radio with a label for each of
the 15 channel groups and a label for each of the 16
channels within each group.
To display the channel number associated with a
channel label:
1. PRESS THE # KEY to display the group number.
2. P
RESS THE # KEY AGAIN to display the channel
number.
3. PRESS AND HOLD THE # KEY to display the
channel label.
4. P
RESS ENT.
Each label can include up to eight characters, with
decimal points available between characters.
Characters can include A–Z, 0–9, -, *, $, /, +, %, \, |,
_, <, >, h, or a blank space.
F i
re ne
ch 1
CHANNEL LABEL
CHANNEL NUMBER
1 2 3
5 6
7 8 9
0
*
#
CLR
FCN
PRI
ENT
RX
SCN
TX
PRG ID CG
P
R
.
.
To Next Page
Loading...
Need help?
General
